倉泵作為氣力輸送系統的關鍵設備，在粉體物料（如粉煤灰、水泥、礦渣）輸送過程中會產生含塵排氣，若直接排放不僅造成物料浪費，還會污染環境。科學的排氣處理方式需兼顧除塵效率、系統能耗與運行穩定性，通過針對性的凈化工藝將排氣中的粉塵濃度控制在排放標準內，同時減少對周邊環境的影響，其處理邏輯圍繞 “捕集 - 分離 - 凈化” 三個核心環節展開。

　　As a key equipment in pneumatic conveying systems, the bin pump generates dust containing exhaust during the transportation of powder materials such as fly ash, cement, and slag. Direct discharge not only causes material waste but also pollutes the environment. The scientific exhaust treatment method needs to take into account dust removal efficiency, system energy consumption, and operational stability. Through targeted purification processes, the dust concentration in the exhaust is controlled within the emission standards, while reducing the impact on the surrounding environment. The treatment logic revolves around the three core links of "capture separation purification".

　　過濾式處理是倉泵排氣最常用的方式，核心是利用過濾介質截留粉塵顆粒。該方式通過在排氣口安裝濾筒或布袋過濾器，當含塵氣體流經過濾材料時，粉塵被阻擋在濾材表面，潔凈氣體透過排出。濾材選擇需適配粉塵特性：對于粒徑較小的粉塵（如水泥粉），選用超細纖維濾布，其微孔結構可截留微米級顆粒；對于粘性粉塵（如粉煤灰），則采用表面光滑的覆膜濾材，減少粉塵附著。為避免濾材堵塞，設備需配備清灰裝置，常見的有脈沖噴吹（通過壓縮空氣瞬間反吹濾材，抖落粉塵）和機械振打（利用振動使粉塵脫落），清灰周期根據粉塵濃度動態調整，確保過濾阻力穩定在合理范圍（通常不超過 1500Pa）。過濾式處理的除塵效率可達 99% 以上，適合粉塵濃度中等、顆粒性質穩定的倉泵排氣場景。

　　Filtering treatment is the most commonly used method for exhaust of warehouse pumps, and the core is to use filtering media to intercept dust particles. This method involves installing a filter cartridge or bag filter at the exhaust port. When the dusty gas flows through the filter material, the dust is blocked on the surface of the filter material, and the clean gas is discharged through it. The selection of filter materials should be adapted to the characteristics of dust: for smaller particle sizes (such as cement powder), ultrafine fiber filter cloth should be used, whose microporous structure can intercept micron sized particles; For viscous dust (such as fly ash), a smooth surface coated filter material is used to reduce dust adhesion. To avoid clogging of the filter material, the equipment needs to be equipped with a dust cleaning device. Common methods include pulse blowing (using compressed air to instantly blow back the filter material and shake off dust) and mechanical vibration (using vibration to make dust fall off). The dust cleaning cycle is dynamically adjusted according to the dust concentration to ensure that the filtration resistance is stable within a reasonable range (usually not exceeding 1500Pa). The dust removal efficiency of filter processing can reach over 99%, suitable for exhaust scenarios of warehouse pumps with medium dust concentration and stable particle properties.

　　旋風分離處理適用于高濃度、大顆粒粉塵的預處理，通過離心力實現氣固分離。含塵排氣進入旋風分離器后，沿筒壁做旋轉運動，粉塵在離心力作用下被甩向器壁，沿錐筒滑落至底部集塵斗，凈化后的氣體從中心管排出。該方式無需濾材，能耗低且維護簡單，但對粒徑小于 5 微米的粉塵截留效果有限（效率約 70%-80%），通常作為前置處理與過濾式組合使用，降低后續過濾設備的負荷。分離器的結構參數需優化設計，如筒體直徑、圓錐角度、進出口尺寸等，確保氣流旋轉速度達到分離要求（通常 12-20m/s），避免因流速過低導致分離效率下降。

　　Cyclone separation treatment is suitable for the pretreatment of high concentration and large particle dust, achieving gas-solid separation through centrifugal force. After entering the cyclone separator, the dusty exhaust gas rotates along the cylinder wall. The dust is thrown towards the wall by centrifugal force and slides down the cone to the bottom dust collector. The purified gas is discharged from the central pipe. This method does not require filter materials, has low energy consumption, and is easy to maintain, but has limited effectiveness in intercepting dust with a particle size of less than 5 microns (efficiency of about 70% -80%). It is usually used as a combination of pre-treatment and filtration to reduce the load on subsequent filtration equipment. The structural parameters of the separator need to be optimized, such as cylinder diameter, cone angle, inlet and outlet dimensions, etc., to ensure that the airflow rotation speed meets the separation requirements (usually 12-20m/s) and avoid a decrease in separation efficiency due to low flow velocity.

　　濕式處理適用于高溫或易燃易爆粉塵的排氣處理，通過水幕或噴淋吸收粉塵。含塵氣體進入洗滌塔后，與噴淋系統形成的水霧充分接觸，粉塵顆粒被水滴吸附形成泥漿，隨水流至底部沉淀池，潔凈氣體經除霧器（去除夾帶的水滴）后排放。該方式的優勢是降溫效果好，可處理溫度超過 200℃的排氣，且能吸收部分有害氣體（如含硫粉塵），但需定期處理廢水（如沉淀池污泥脫水），避免二次污染。對于粘性大的粉塵，需在洗滌液中添加分散劑，防止管道堵塞；對于疏水性粉塵，則加入表面活性劑增強粉塵與水滴的結合能力，提升吸收效率。

　　Wet treatment is suitable for exhaust treatment of high temperature or flammable and explosive dust, absorbing dust through water curtains or sprays. After entering the washing tower, the dusty gas comes into full contact with the water mist formed by the spray system. The dust particles are adsorbed by water droplets to form a slurry, which flows with the water to the bottom sedimentation tank. The clean gas is discharged after passing through the demister (removing the entrained water droplets). The advantage of this method is its good cooling effect, which can handle exhaust gases with temperatures exceeding 200 ℃, and can absorb some harmful gases (such as sulfur-containing dust). However, it requires regular treatment of wastewater (such as sludge dewatering in sedimentation tanks) to avoid secondary pollution. For highly viscous dust, a dispersant should be added to the washing solution to prevent pipeline blockage; For hydrophobic dust, surfactants are added to enhance the binding ability between dust and water droplets, thereby improving absorption efficiency.

　　排氣處理系統的協同控制是保障穩定運行的關鍵，需與倉泵工作周期聯動。倉泵卸料階段排氣量驟增，控制系統需自動調大引風機功率，確保排氣順暢進入處理設備；在待機階段則降低風量，減少能耗。壓力傳感器實時監測處理系統的阻力變化，當阻力異常升高（如濾材堵塞、管道積灰）時，發出報警并啟動應急清灰或停機程序，避免系統超壓損壞。對于連續運行的倉泵，處理設備需配備備用過濾單元，在主單元維護時自動切換，確保排氣處理不中斷。

　　The collaborative control of the exhaust treatment system is the key to ensuring stable operation and needs to be linked with the working cycle of the bin pump. The exhaust volume during the unloading stage of the warehouse pump suddenly increases, and the control system needs to automatically increase the power of the induced draft fan to ensure smooth exhaust entering the processing equipment; Reduce air volume and energy consumption during standby mode. The pressure sensor monitors and processes the resistance changes of the system in real time. When the resistance abnormally increases (such as filter material blockage or pipeline dust accumulation), an alarm is issued and emergency dust cleaning or shutdown procedures are initiated to avoid system overpressure damage. For continuous operation of the bin pump, the processing equipment needs to be equipped with a backup filtration unit that automatically switches during maintenance of the main unit to ensure uninterrupted exhaust treatment.

　　不同場景的處理方式選擇需結合實際需求：小型倉泵（如車間內輸送設備）適合單機過濾式處理，占地面積小且安裝靈活；大型倉泵系統（如電廠粉煤灰輸送）宜采用 “旋風分離 + 布袋過濾” 的組合工藝，兼顧處理量與凈化效果；存在粉塵爆炸風險的場合（如煤粉輸送）必須選用濕式處理或防爆型過濾設備，且系統需做防靜電接地。處理后的粉塵可根據性質回收利用，如水泥粉塵回用于生產，礦渣粉塵作為建材原料，實現資源循環。

　　The selection of processing methods for different scenarios should be based on actual needs: small bin pumps (such as conveying equipment in workshops) are suitable for single machine filtration processing, with a small footprint and flexible installation; Large scale warehouse pump systems (such as power plant fly ash transportation) should adopt a combination process of "cyclone separation+bag filtration" to balance processing capacity and purification effect; In situations where there is a risk of dust explosion (such as coal powder transportation), wet treatment or explosion-proof filtration equipment must be selected, and the system must be grounded to prevent static electricity. The processed dust can be recycled according to its properties, such as cement dust being reused in production and slag dust being used as building materials to achieve resource recycling.

　　本文由倉泵友情奉獻.更多有關的知識請點擊:http://m.kingwanlan.com我們將會對您提出的疑問進行詳細的解答，歡迎您登錄網站留言.

　　This article is a friendly contribution from Roots blower For more information, please click: http://m.kingwanlan.com We will provide detailed answers to your questions. You are welcome to log in to our website and leave a messag