一、脈沖除塵器簡介脈沖除塵器，是以壓縮空氣為清灰動力，利用脈沖噴吹機構在瞬間放出壓縮空氣，誘導數倍的二次空氣高速攝入濾袋，使濾袋急劇膨脹，依靠沖擊振動和反向氣流而清灰的除塵器。脈沖式除塵器是一種高效除塵凈化設備，采用脈沖噴吹的清灰方式，具有清灰效果好、凈化效率高、處理氣量大、濾袋壽命長、維修工作量小、運行安全可靠等優點；但需要壓縮空氣，而且當供給的壓縮空氣壓力不能滿足要求時，請回效果會大大降低。由于脈沖袋式除塵器優點突出，所以，它的應用越來越廣泛。脈沖除塵氣具有多種形式，如逆噴、順噴、對噴、旋轉噴吹等。吹氣源壓為低于0.25MPa者成為低壓噴吹；吹氣源壓為高于0. 5MPa者成為高壓噴吹。二、脈沖除塵器工作原理圖以脈沖袋式除塵器為例，工作原理如下圖所示。脈沖閥一端接壓縮空氣包，另一端接噴吹管，脈沖閥背壓室接控制閥，脈沖控制儀控制著控制閥及脈沖閥開啟。

1、 Introduction to Pulse Dust Collector Pulse dust collector is a dust collector that uses compressed air as the cleaning power, and uses a pulse blowing mechanism to instantly release compressed air, inducing several times the secondary air to enter the filter bag at high speed, causing the filter bag to rapidly expand, and relying on impact vibration and reverse airflow to clean the dust. Pulse type dust collector is an efficient dust removal and purification equipment that uses pulse blowing for dust cleaning. It has the advantages of good dust cleaning effect, high purification efficiency, large gas processing capacity, long filter bag life, low maintenance workload, and safe and reliable operation; But compressed air is required, and when the supplied compressed air pressure cannot meet the requirements, the return effect will be greatly reduced. Due to the outstanding advantages of pulse bag filter, its application is becoming increasingly widespread. Pulse dust removal gas has various forms, such as reverse spray, forward spray, counter spray, rotary spray, etc. If the blowing source pressure is lower than 0.25MPa, it becomes low-pressure blowing; A blowing source pressure higher than 0.5 MPa is called high-pressure blowing. 2、 The working principle diagram of the pulse dust collector takes the pulse bag filter as an example, and the working principle is shown in the following figure. One end of the pulse valve is connected to the compressed air bag, and the other end is connected to the spray pipe. The back pressure chamber of the pulse valve is connected to the control valve, and the pulse controller controls the opening of the control valve and pulse valve.

當控制儀無信號輸出時，控制閥的排氣口被關閉，脈沖閥噴口處關閉狀態；當控制儀發出信號時控制排氣口被打開，脈沖閥背壓室外的氣體泄掉壓力降低，膜片兩面產生壓差，膜片因壓差作用而產生位移，脈沖閥噴吹打開，此時壓縮空氣從氣包通過脈沖閥經噴吹管小孔噴出(從噴吹管?chē)姵龅臍怏w為一次風)。當高速氣流通過文氏管誘導器誘導了數倍于一次風的周?chē)諝猓ǚQ(chēng)為二次風）進入濾袋，造成濾袋內瞬時正壓，實現清灰。了解脈沖除塵器的基礎知識，是設計或正確選型的基礎。并且，根據我們過去積累的經驗，我們還對脈沖除塵器清灰裝置的選型理論做了如下論述。三、脈沖除塵器清灰裝置的選型設計脈沖除塵器清灰裝置由脈沖閥、噴吹管、貯氣包、導流器和控制儀等幾部分組成。其設計選型主要包括氣源氣包設計、噴吹管設計和電磁脈沖閥選型3大項。

When there is no signal output from the controller, the exhaust port of the control valve is closed and the pulse valve nozzle is in a closed state; When the controller sends a signal, the control exhaust port is opened, and the gas outside the pulse valve back pressure chamber is released, reducing the pressure. A pressure difference is generated on both sides of the diaphragm, and the diaphragm is displaced due to the pressure difference. The pulse valve is blown open, and at this time, compressed air is blown out from the gas bag through the pulse valve through the small hole of the blowing pipe (the gas sprayed out from the blowing pipe is primary air). When the high-speed airflow induces several times the surrounding air (called secondary air) through the Venturi tube inducer to enter the filter bag, causing instantaneous positive pressure inside the filter bag and achieving dust cleaning. Understanding the basic knowledge of pulse dust collectors is the foundation for designing or selecting them correctly. Moreover, based on our accumulated experience in the past, we have also made the following discussion on the selection theory of the pulse dust collector cleaning device. 3、 The selection and design of the pulse dust collector cleaning device. The pulse dust collector cleaning device consists of several parts such as pulse valve, spray pipe, gas storage bag, guide vane, and control instrument. The design selection mainly includes three items: gas source package design, spray pipe design, and electromagnetic pulse valve selection.

本文由鑫魯泉盛友情奉獻.更多有關的知識請點擊:http://m.kingwanlan.com/news/真誠的態度.為您提供為全面的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.

This article is contributed by Xinlu Quansheng Friendship. For more related knowledge, please click: http://m.kingwanlan.com/news/ Sincere attitude. We provide you with comprehensive services. We will gradually contribute more relevant knowledge to everyone. Please stay tuned